Cut-True 13MManual Paper CutterOPERATOR MANUAL FIRST EDITION4/2015
MAINTENANCEREPLACING THE CUTTING STICKAll moving parts with screws should be checked periodically to be sure the screws are tight. They may become loo
REPLACING THE CUTTING BLADE1. Remove the blade lever arm and the blade housing cover. Then reinstall the blade lever arm.4. Remove the two outer scr
97. Carefully remove the old blade from the blade change tools. Set the blade on a at surface and unscrew the handles. Cap the old blade with a prote
TOPIC PAGESpecications 1Safety Guidelines 1Assembly 2Overview 3Description of Equipment Parts 4Operation 5-6Maintenance 7Replacing the Cutting Stick
SAFETY GUIDELINESSPECIFICATIONS* Operators should read this manual prior to using the cutter* The Cut-True 13M should only be used by one person at a
ASSEMBLY2Rear Safety CoverRear safety coverBlade lever armRemove the four screws indicated in g 1. Insert the rear safety cover with the notch under
1. Blade lever arm2. Front safety guard3. Blade lever locking safety arm4. LED laser light switch5. Blade lever safety release6. Blade adj
DESCRIPTION OF EQUIPMENT PARTS1. Blade Lever Arm Lever-action provides robust cutting with minimal effort. After each cut, the lever must be returned
1. Turn on the LED Laser Light.2. Raise the blade lever arm to the upright, locked posi-tion.3. Loosen the back gauge thumbscrew and slide the back ga
7. Grasp the blade lever arm and lower it slightly while at the same time sliding the safety lever to the right (inset) to engage the blade lever arm
Commentaires sur ces manuels