Formax FD 380 Manuel d'utilisateur

FD 380Document FolderOPERATOR MANUAL THIRD EDITION2/08

BATCH COUNTING1. To enter the manual batch counting mode press the “Batch Count” button and select “MANUBATCH” by pressing the “+” button (Fig 8) .2.

MULTI-SHEET FEEDINGThe multi-sheet feeder is designed to fold pre-collated stapled or unstapled sets of up to three 20 # sheets of paper. 1. Adjust

8CROSS FOLDINGCross folding refers to folding a document in one pass and then running it through the folder a second time to be folded again.Common Ap

Thicker paper from 28 # up to 65 # may require special stacker wheel setup moving the stacker wheels closer than the position “A” slot. If stacking i

OPERATOR MAINTENANCE1. It is recommended to let forms cool for one-half hour, from the laser printer, before folding. This allows toner to set on th

TROUBLE-SHOOTINGTROUBLEPOSSIBLE CAUSEREMEDYControl panel lights are not illuminated.No power at the wall outlet.No power to the machine inlet.No power

TABLE OF CONTENTSSUBJECTPAGEDESCRIPTION1SPECIFICATIONS1UNPACKING1SETUP2CONTROL PANEL 3OPERATION4SETTING CUSTOM FOLDS 5BATCH COUNTING6MULTI-SHEET FEEDE

Paper size: 3.5” x 5” to 11” x 17” (88.9 W x 127 L to 311W x 432 L mm) Fold types:Letter , Zig-Zag , Single , Gate , Fold Out ,Do

SETUP1. Install upper and lower fold plates in position. Be sure the plates are set fi rmly on the locating pins (Fig 1a & 1b). Slide the fold pla

CONTROL PANEL3No. NAME FUNCTION1Standard Folds Menu Select the desired pre programmed fold.2Start/Stop ButtonPress to start or stop the machine.3Speed

OPERATION1. Place power switch in the “ON” position.2. Extend the catch tray as required.3. Move the stacker wheels to the proper position for the

SETTING CUSTOM FOLDSExample 1: Uneven “Z”a. Measure the length of panel “A” & “B”b. Measure the length of panel “B”c. Enter these measurements acc