Formax FD 540 Manuel d'utilisateur

FD 540BursterOPERATOR MANUALFIRST EDITION

10. If necessary, readjust the position of the Feed Roller Carriage so that the form starts to burst when the perforation is just under the Tear Bar.N

9SET-UP PROCEDURES FORMODELS WITH SLITTERSFOLLOW FORM SET-UP PROCEDURES 1 THRU 9 AND PROCEED AS FOLLOWS.1. Noting the Blade Indicator Marks on the Upp

10

IMPRINTER, SLITTERS ANDTRACTORS SET-UP PROCEDURESNOTE: It is recommended that forms or checks fed into imprinter should be last form first, right

10. Turn Handwheel until Signature is printed on second check.11. Located at the right end of the Imprint Cylinder shaft is the timing collar.

TROUBLESHOOTINGFeeding, Bursting, and Stacking problems ar usually due to improper adjustment of the machine to the forms or due to non-standaTd

SYMPTOM PROBABLE CAUSELarge variation in trim accuracy. Upper/Lower Side Guides too loose/tight. Paper pack not centered to Slitter

TABLE OF CONTENTSDESCRIPTION Function ...1 Model Numbe

DESCRIPTIONFUNCTION The 920 Burster bursts (breaks apart) single and multi-part continuous forms and feeds them sequentially onto the stacker. The opt

2INSTALLATIONUNPACKINGDo, not destroy the shipping cartons or materials until the machine has been inspected for shipping damage, missing parts, and p

36. Place the stacker wheel assembly on the stacker wheel adjustment rack. (Fig. 5)7. Place urge roller on stacker tray so that it rests on the stacke

4OPERATIONGENERALThis section describes the controls, features, and normal operating procedures for the FD 540 Series Burster. This section also ident

5CONTROL/FEATURE FUNCTIONOn/Off Switch Controls power to the Burster. Provides protection for the operator and the machine against accidental gro

6CONTROL/FEATURE FUNCTIONGuide Wire Indicator Marks Indicates where the Guide wires are withing the machine Form Setting Indicator

7FORM SET-UP PROCEDURE1. Without table, machine should be positioned on an ordinary table with the Slitter Unit overhanging the edge. T