Formax FD 1502 Plus Manuel d'utilisateur

FD 1502Plus AutoSeal®OPERATOR MANUALFIRST EDITION6/2014

Figure 6Figure 76DAILY MAINTENANCE1. It is recommended to let forms cool for one-half hour, from the laser printer, before folding and seal-ing. Thi

7TROUBLESHOOTINGB. Fold Quality Needs Improving:1. Make sure paper is squared and installed correctly. Side guides should be evenly balanced and

INSTALLING OPTIONAL FLOW STRAPSFigure 9Figure 113. With strap in place, press clip down over strap. (Figure 11)4. Figure 12 shows strap and clip in p

DETERMINING FOLD TYPETwo Standard Folds 11” “Z” & 11” “C” Refer to page 5 for custom fold setup.11” “Z” Fold11” “C” FoldLeading glue edgeLeading g

hLeading EdgeMake copies of this page on copy paper for ne tuning foldsInstruction For Lining Up FoldsFig. 17 “C” Fold FormFold “A” Fold “B” Leading

TABLE OF CONTENTSTOPIC PAGEDESCRIPTION 1SPECIFICATIONS 1UNPACKING AND SET-UP 2CONTROL PANEL 3OPERATION 3FOLD PLATE ADJUSTMENT 4 - 5SETTING CUSTOM FOLD

1DESCRIPTIONFUNCTION:The 1502Plus Pressure Sealer folds and seals many different congurations, including “C”, “Z”, “V” and custom folds. It also acc

2UNPACKING AND SET UP, continued5. To attach the conveyor to the out-feed, align the tab on the right side of the conveyor with the slot on the machi

3OPERATION1. Adjust fold plates to desired fold for length of paper (see fold plate adjustment on page 4). To do this, loosen the two thumbscrews (Fi

FOLD PLATE ADJUSTMENT1. To adjust the rst fold remove the top cover to access the top fold plate. If the rst fold is too long loosen the two thumb

SETTING CUSTOM FOLDSEccentric “Z”1. Measure the length of panel “A”.2. Adjust the upper fold plate so that the bar lines up with the measurements of p