Formax FD 372 Manuel d'utilisateur

1 FORMAX FD 372 Document Folder âOperator Manual First Edition

10(6)Preparation Install Table 1 and 2. Insert the front cut-away section of Table 1 onto the stud (1) of the machine and drop its rear cut-away s

11Insert the power cord into the outlet. Caution: Be sure to unwind cord before use. Do not use any power cord other than provided as an accessory

12(7) Operation (A) Standard folding of standard-size paper How to perform standard folding of standard-size paper: Flip power switch to on posit

13Choosing a fold type: One of the six folding types (Single, Gate, Letter, Zigzag, Double Parallel, Fold-out) can be chosen by pressing the desired

14 (B) Manually Setting Standard Folding of Non-standard-size Paper Determine the Paper Length Measure the paper length in inches. The arrow in

15 Fold -Stopper Position Chart Table 1 Table 2 SINGLE Original position 1/2 GATE 1/4 1/2 LETTER 1/3 1/3 ZIGZAG 2/

16Setting the paper discharge roller: The discharge roller should be moved to the proper position that suits the paper size. Note: Refer to “Rolle

17 (C) Cross Folding Cross folding refers to performing the double parallel, letter, or other types of folds for the sheets of paper folded using the

18(8) Adjustments (A) Feed Angle /Skew Adjustments If the folding position is slanted because the edges of the paper are slanted or for other reason

19 Adjusting Table 2 Press the Select key and select the Table 2 stopper move mode. Next press the +/- key and move the stopper to the desired p

2 Introduction Thank you very much for purchasing the FD 372 Document Folder. This machine enables users to achieve greater efficiency at work by re

20 Fine Adjustments for Table 1 Fold type Plane (A)Direction to turn the Table 1 fine adjustment knob Single fold Table 1 is not used Long Ga

21 Short Long Double parallel fold Short Long Fold-out Short

22Fine Adjustments for Table 2 Fold type Plane (B)Direction to turn the Table 2 fine adjustment knob Long Single fold Short Long Gate fold Shor

23(9)Storing Custom Folds in Memory (A)Memory Storage Custom fold types can be stored into the fold type keys in replacement of the factory set f

24 Storing the fold into Memory Select the fold type key the storage will be input. Press and hold the Store key, release immediately when the alarm

25Press and hold the Clear/Reset key, release immediately when the alarm rings once. The lamp for the fold key will stop blinking when the memory h

26

3 (1) Specifications Model: FD 372 Paper sizes: 3.5” x 5.0” to 11” x 17” Smaller size for single fold only. Paper quality: High-quality paper, hig

4 (2) Accessories Make sure that the following accessories are included in the package after opening it. Contact your sales agency immediately if th

5(3) Description of Parts Number Name Number Name 1 Roller cover 11 Paper feed table 2 Left side cover 12 Table 2 3 Paper feed rol

7 (4)Designation and Functions of Operation Panel No. Designation/Indication Function 1 Fold type key Six folding types can be input and stored.

815 Table 2 stopper move mode lamp It is on when the position of stopper of Table 1 is adjusted. 16 Paper size paper size input mode lamp It is on

9(B) Batch Counting As a sheet is folded, the number indicated on the counter decreases by one. Press the Select key and select the Counter Input M